Skip to content Skip to footer

LARTON AM K/30

$1.00

LARTON AM K/30 is a technical PPS (Polyphenylene Sulphide) based compound reinforced with 30% carbon fibre. Featuring outstanding mechanical properties, antistaticity (ATEX environments), high temperature resistance and self-extinguishing, good chemical and hydrolysis resistance, it is optimised for direct-to-granule (FGF) 3D printing.

Base polymer PPS

Fillers/Reinforcements Carbon fibers

Mechanical properties High mechanical properties
Chemical-physical properties Low moisture absorption, High chemical resistance
Thermal properties High thermal resistance
3D Printing Only for direct printing from granule
Functional properties Self-extinguishing, Antistaticity (ATEX)/ Electrical conductivity
Granule drying conditions 100°C
Filament extrusion conditionsExtrusion temperature: 290°C – 310°C
Filament drying temperature: 90°C
3D printing conditionsExtruder temperature: 310°C – 330°C
Bed temperature: 90°C – 110°C
Recommended Nozzle: steel nozzle
Cooling: OFF
Post-annealing conditions: 130°C 1h x 1mm
Other: Ideal CLOSED and thermostat-controlled ROOM
Richiedi info

Description

LARTON AM K/30 is a technical PPS (Polyphenylene Sulphide) based compound reinforced with 30% carbon fibre. Featuring outstanding mechanical properties, antistaticity (ATEX environments), high temperature resistance and self-extinguishing, good chemical and hydrolysis resistance, it is optimised for direct-to-granule (FGF) 3D printing.

Base polymer PPS

Fillers/Reinforcements Carbon fibers

Mechanical properties High mechanical properties
Chemical-physical properties Low moisture absorption, High chemical resistance
Thermal properties High thermal resistance
3D Printing Only for direct printing from granule
Functional properties Self-extinguishing, Antistaticity (ATEX)/ Electrical conductivity
Granule drying conditions 100°C
Filament extrusion conditionsExtrusion temperature: 290°C – 310°C
Filament drying temperature: 90°C
3D printing conditionsExtruder temperature: 310°C – 330°C
Bed temperature: 90°C – 110°C
Recommended Nozzle: steel nozzle
Cooling: OFF
Post-annealing conditions: 130°C 1h x 1mm
Other: Ideal CLOSED and thermostat-controlled ROOM
Richiedi info

Additional information

Disponibile in

Polimero base

Filler/rinforzi

Proprietà termiche

Proprietà fisiche

,

Proprietà meccaniche

Proprietà funzionali

,

Stampa 3D

Categoria

, , ,

RequestDataSheet

Download

Info


This will close in 0 seconds

Datasheet


This will close in 0 seconds

Iscrizione alla newsletter


This will close in 0 seconds

Subscribe our newsletter


This will close in 0 seconds